Integra DTR-70.1(N) Service Manual page 3

QQ
3 7 63 1515 0
SERVICE PROCEDURE-2
5. To check version of Microprocessor, DSP and Video FW(Firmware)
1. Press and hold down DISPLAY button, then press ON/STANDBY button when the unit is power on.
The main microprocessor version will be displayed on Front Display for about 3 seconds.
[e.g.]
2. [TX-NR1007, NR3007, NR5007, PR-SC5507]
Press (TONE) button while the version is displayed. Then, version of DSP FW will be displayed.
In this way, as
If (TONE) button is pressed, the order will be reversed.
[DTR-70.1, DTR-80.1, DHC-80.1]
Press (Tone) button while the version is displayed. Then, version of DSP FW will be displayed.
In this way, as
If (Tone) button is pressed, the order will be reversed.
[e.g.] In case TX-NR5007
<Note> Number depends on the version.
(TONE)
(Tone)
M a i n :
1 .2 2 /0 9 Z 1 1 A H
DSP 1st/NET:
TE
L 13942296513
1 .1 4 /0 9 X 2 3 A H A
DS P 2 n d :
1 .0 3 /0 9 7 2 3 A H 2
DS P 3 r d :
1 .0 5 /0 9 9 1 4 A H 3
V i d e o :
1 .1 3 /0 9 Y 0 2 A R
V S P ( R e o n ) :
1 .0 3 /0 9 Z 1 1 A E O
www
3. Press ON/STANDBY button to power off.
.
http://www.xiaoyu163.com
M a i n :
1 .2 2 /0 9 Z 1 1 A H
(TONE) button is pressed while a version is displayed, the next information will be displayed.
(Tone) button is pressed while a version is displayed, the next information will be displayed.
(TONE)
(Tone)
x ao
y
i
http://www.xiaoyu163.com
8
Version of Main Microprocessor FW
Q Q
3 6 7 1 3
Version of 1st DSP FW
Version of 2nd DSP FW
Version of 3rd DSP FW
Version of Video Microprocessor FW
V id e o:
1 . 1 3/ 09Y0 2AR
[TX-NR1007]
AT
[TX-NR5007, NR3007, PR-SC5507, DTR-70.1, DTR-80.1, DHC-80.1]
AR
Version of VSP(Video Signal Processor) FW
[TX-NR1007]
Torino
[TX-NR5007, NR3007, PR-SC5507, DTR-70.1, DTR-80.1, DHC-80.1]
Reon
V S P (Reon):
1 . 0 3/ 09Z 11 AEO
u163
[TX-NR5007, NR3007, NR1007, PR-SC5507]
.
AEO
[DTR-70.1, DTR-80.1, DHC-80.1]
AEI
2 9 9 4 2 8
1 5 0 5 8 2 9 9 4
m
co
TX-NR3007
9 9
2 8 9 9