Icom IC-F61-L Instruction Manual page 7

Hide thumbs Also See for IC-F61-L:
Table of Contents

Advertisement

DO NOT push [PTT] when you do not actually intend to transmit.
DO NOT operate or place the transceiver in direct sunlight or in
areas with temperatures below –20°C or above +55°C.
DO NOT modify the transceiver. The specifications may change
and then not comply with the requirements of a corresponded reg-
ulation. The transceiver warranty does not cover any problems
caused by unauthorized modification.
DO NOT use harsh solvents such as benzine or alcohol when
cleaning, as they will damage the transceiver surfaces.
BE CAREFUL! The transceiver will become hot when operating it
continuously for long periods of time.
BE CAREFUL! The transceiver meets IP67* requirements for dust-
tight and waterproof protection. However, once the transceiver has
been dropped, dust-tight and waterproof protection cannot be guar-
anteed because of possible damage to the transceiver's case or
the waterproof seal.
* Only when the battery pack and jack cover are attached.
Even when the transceiver power is OFF, a slight current still flows
in the circuits. Remove the battery pack or batteries from the trans-
ceiver when not using it for a long time. Otherwise, the installed
battery pack or batteries will become exhausted, and will need to
be recharged or replaced.
MAKE SURE to turn OFF the transceiver power before connect ing
the supplied/optional equipment.
Icom, Icom Inc. and Icom logo are registered trademarks of Icom Incorporated
(Japan) in Japan, the United States, United Kingdom, Germany, France, Spain,
Russia, Australia, New Zealand, and/or other countries.
vi

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the IC-F61-L and is the answer not in the manual?

This manual is also suitable for:

Ic-f51Ic-f61

Table of Contents