Indoor Unit Installation Drawings - Daikin FTXS60GV1B Installation Manual

Indoor Unit Installation Drawings

Screws
(field supply: M4 × 25L)
Front panel
50mm or more from walls
(on both sides)
Air filters
B Titanium apatite photocatalytic
air-purifying filter (2)
Filter frame
Tab
INTELLIGENT EYE sensor
CAUTION
• Do not hit or violently push the INTELLIGENT EYE sensor. This can lead to damage and malfunction.
• Do not place large objects near the sensor. Also keep heating units or humidifiers outside the sensor's detection area.
3
A Mounting plate
The mounting plate
should be installed on a
wall which can support the
weight of the indoor unit.
Screws
(M4 × 16L)
Titanium apatite
photocatalytic
air-purifying filter
Air filter
How to attach the indoor unit
Hook the claws of the bottom frame
to the mounting plate.
If the claws are difficult to hook,
remove the front grille.
How to remove the indoor unit
Push up the marked area (at the
lower part of the front grille) to
release the claws. If it is difficult to
release, remove the front grille.
30mm or more
from ceiling
INTELLIGENT EYE
sensor
Service lid
Opening service lid
Service lid is opening/closing type.
Opening method
1) Remove the service lid screws.
2) Pull out the service lid diagonally
down in the direction of the arrow.
3) Pull down.
Fixing screws for remote
controller holder
(field supply: M3 × 20L)
Front grille
Cut thermal insulation
pipe to an appropriate
Caulk
length and wrap it with
pipe hole
tape, making sure that no
gap
gap is left in the insulation
with putty.
pipe's cut line.
Wrap the insulation pipe with
the finishing tape from bottom
to top.
Before screwing the remote
C
controller holder to the wall,
Wireless
make sure that control
remote
signals are properly
controller
received by indoor unit.
D
Remote
controller holder
A Mounting
plate
Clip
Bottom frame
Mark (rear side)
■English