Problems With Hdmi - Epson EH-TW5350 User Manual

Troubleshooting
Check
Is 3D Display set to 2D?
Is 3D Format set correctly?
Are you viewing within the reception range? If the distance between the projector and the 3D Glasses exceed
Has pairing been performed correctly?
Are there any devices that cause radio wave
interference in the vicinity?

Problems with HDMI

HDMI Link does not function
Check
Are you using a cable that meets the HDMI
standards?
Does the connected device meet the HDMI
CEC standards?
Are the cables connected correctly?
Is the power for the amplifier or DVD recorder
and so on turned on?
Was a new device connected, or was the con-
nection changed?
Are many multi-media players connected?
If 3D Display is set to 2D from the Configuration menu, the pro-
jector does not automatically change to 3D even when a 3D im-
age is input. Press the
3D or Auto. Signal - 3D Setup - 3D Display
s
Unless the 3D format of the AV device and 3D Format of the
projector are the same, part of the image may not be displayed.
Check that the projector's 3D Format setting matches the 3D
format setting for the AV device.
mat p.66
When changing the 3D Format, set 3D Display to Auto, and
then press the button.
10 m, the connection may be lost. Move the 3D Glasses closer to
the projector.
See the User's Guide for the 3D Glasses to perform pairing.
When using other devices at the same time with the frequency
band (2.4 GHz) such as Bluetooth communication devices, wire-
less LAN (IEEE802.11b/g), or microwave ovens, radio wave inter-
ference may occur, the image may be interrupted, or communi-
cation may not be possible. Do not use the projector near these
devices.
Operations are not possible with cables that do not meet the
HDMI standards.
If the connected device does not meet the HDMI CEC standards,
it cannot be operated even if it is connected to the HDMI port.
See the documentation and so on supplied with the connected
device for more information.
Also, press the button, and then check if the device is
available under Device Connections.
Check that all the cables required to use HDMI Link are securely
connected. p.48
s
Put each device in standby status. See the documentation and
so on supplied with the connected device for more information.
If you have connected a speaker and so on, set the connected
equipment to PCM output.
If the CEC function for a connected device needs to be set again,
for example when a new device is connected or the connection
is changed, you may need to restart the device.
Up to 3 multi-media players that meet the HDMI CEC standards
can be connected at the same time.
84
Remedy
button, and then set 3D Display to
p.66
Signal - 3D Setup - 3D For‐
s
Remedy
p.49
s