Install Anti-Tip Bracket - Bosch HES232U Installation Instructions Manual

STEPS 4 AND 5: INSTALL ANTI-TIP BRACKET AND FINAL INSTALL
Warming Drawer
Figure 6
4

INSTALL ANTI-TIP BRACKET:

1. Adjust height of range and level by rotating the adjustable
leg supports, (see Figure 6) using 1-1/4" wrench.
2. Measure to locate bracket position as shown in Figure 7.
3. Secure bracket with 2 screws.
5
FINAL INSTALL:
1. Move range close enough to the opening to plug into the
receptacle.
2. Slide range into position insuring that the left back leg slides
under the anti-tip bracket. Range will sit 3/4" away from back
wall when properly installed.
3. Carefully tip range forward to insure that the anti-tip bracket
engages the range back brace and prevents tip-over.
4. Turn on electrical power. Check range for proper operation as
described in Use and Care Manual.
Note: if LCD screen flashes and beeps, the wiring is incorrectly
installed. Immediately disconnect power at breaker and return to
step 3: CONNECT RANGE CORD.
WARNING
• ALL RANGES CAN TIP.
• INJURY TO PERSONS COULD
RESULT
• INSTALL ANTI-TIP DEVICE
PACKAGED WITH RANGE.
SEE INSTALLATION INSTRUCTIONS
Wrench
Adjustable legs
CAUTION
DO NOT USE HAND TRUCK
OR APPLIANCE DOLLY ON
THE BACK OR FRONT OF
THIS UNIT. HANDLE FROM
SIDE ONLY!
Figure 7
Figure 8
Screw
Figure 9
Page 6
Flush
Screw
Screw
Screw
WARNING
ELECTRICAL SHOCK
HAZARD - DISCONNECT
POWER BEFORE
SERVICING.
FAILURE TO DO SO CAN
RESULT IN DEATH OR
ELECTRICAL SHOCK.