Airstream INTERNATIONAL TRAILER Owner's Manual page 59

AIRSTREAM INTERNATIONAL TRAILER OWNERS MANUAL
SMOKE ALARM - FIREX MODEL B
Maple Chase Company
2820 Thatcher Road
Downers Grove, Illinois 60515-4040
IMPORTANT INFORMATION-SMOKE ALARM SAFETY CHECKLIST
1. Test your smoke alarm every week. To test the electronics, firmly depress the button. To test that smoke
reaches the sensor, blow smoke in a careful fire-safe manner into your smoke alarm.
2. Your smoke alarm will not work without power. Never shut off its power or remove the battery to quiet
the alarm. FOR BATTERY-POWERED UNITS: When your smoke alarm "beeps" about once a minute, the
battery is weak. Immediately install a new battery correctly. Be sure to use only batteries specified in
Owner's Manual or on unit. Test unit after installing a new battery.
3. Clean and vacuum the openings on your smoke alarm once a month.
4. Do not open the smoke alarm or try to repair it. For replacement information see the WARRANTY in the
Owner's Manual.
5. Verify you have the proper number of smoke alarms in your home and the correct location for each one.
A smoke alarm will not respond well in an incorrect location.
6. If your smoke alarm has one or more of these special features, please note:

FALSE ALARM CONTROL (Model C): Pushing test/hush button reduces sensitivity for up to 15
minutes, minimizing nuisance alarms,

FLASHING LIGHT (Model E): Pushing test button turns flashing safety light on. Very thick
smoke may obscure light.
7. Smoke alarms have technical limitations and may not respond in all situations. FIRE PREVENTION is
your best safeguard.
8. For a replacement Owner's Manual or Safety Checklist, please indicate your unit model, include a self-
addressed stamped envelope and send to:
WEEKLY TESTING OF YOUR SMOKE ALARM
1. FOR A COMPLETE WEEKLY TEST OF THE ELECTRONICS AND THE SENSOR OPERATION,
FIRMLY DEPRESS THE TEST BUTTON ON THE COVER OF THE SMOKE ALARM FOR A FEW
SECONDS. The smoke LED (light emitting diode), which is the indicator light under the clear Push-to-
Test button, will blink once per second while the button is being pushed and the alarm is sounding. The
smoke alarm will stop sounding when you release the button.
2. If your smoke alarm has the False Alarm Control or Safety Light feature see "SPECIAL SMOKE
ALARM FEATURES" for further testing information.
3. IMPORTANT: Always test your smoke alarm upon returning from vacation, or any other time when no
one has been in your household or residence for several days.
4. If a smoke alarm is installed in a mobile home, test the smoke alarm after you remove the vehicle from
storage and before each trip.
WARNING
: If your smoke alarm does not respond as described in any of the above tests,
check that a good battery is properly installed. If a good battery is properly installed, promptly
remove the unit, repack it and return it for repair or replacement.
E-5