Power Connection - JVC DLA-VS2000 Instructions Manual

DLA-VS2000_Safety.fm Page 4 Sunday, August 24, 2008 7:38 PM
Getting Started
1
Safety Precautions (Continued)

POWER CONNECTION

For USA and Canada only
Use only the following power cord.
Power cord
The power supply voltage rating of this product is AC110 V
– AC240 V. Use only the power cord designated by our dealer
to ensure Safety and EMC.
Ensure that the power cable used for the projector is the
correct type for the AC outlet in your country. Consult your
product dealer.
Power cord
For European Countries
WARNING:
Do not cut off the main plug from this equipment.
If the plug fitted is not suitable for the power points in your
home or the cable is too short to reach a power point, then
obtain an appropriate safety approved extension lead or
adapter or consult your dealer.
If nonetheless the mains plug is cut off, dispose of the plug
immediately, to avoid a possible shock hazard by inadvertent
connection to the main supply. If a new main plug has to be
fitted, then follow the instruction given below.
WARNING:
THIS APPARATUS MUST BE EARTHED.
IMPORTANT:
The wires in the mains lead on this product are coloured in
accordance with the following cord:
Green-and-yellow : Earth
Blue : Neutral
Brown : Live
As these colours may not correspond with the coloured
making identifying the terminals in your plug, proceed as
follows:
The wire which is coloured green-and-yellow must be
connected to the terminal which is marked M with the letter E
or the safety earth or coloured green or green-and-yellow.
The wire which is coloured blue must be connected to the
terminal which is marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the
terminal which is marked with the letter L or coloured red.
4
If this symbol is shown, it is only valid in the
European Union.