Installing The Display Assembly; Removing The System Board - Dell Precision 15 7000 Series 7510 Owner's Manual

Installing the display assembly

1. Tighten the screws to secure the display assembly in place.
2. Affix the tape on the heat pipe.
3. Connect the eDP cable to the correct connectors on the system board.
4. Insert the wireless antenna cables through the routing hole on the chassis.
5. Tighten the screws at the bottom and back of the computer.
6. Align the display hinge cap and tighten the screws to secure it to the computer.
7. Route and connect the antenna cables to their connectors.
8. Install the:
a. palmrest
b. WWAN card
c. WLAN card
d. keyboard
e. hard drive
f. base cover
g. battery
h. battery cover
9. Follow the procedure in

Removing the system board

1. Follow the procedure in
2. Remove the:
a. SD card
b. battery cover
c. battery
d. base cover
e. hard drive
f. keyboard
g. HDD cable
After working inside your computer
Before working inside your computer.
29