Information On The Display Panel; Faults And What To Do About Them - Bosch WAE24461GB Series Instruction Manual And Installation Instructions

Information on the display panel

Display
YES
NO
NO flashes
F:16
F:17
F:18
F:21
F:23
E
N flashes

Faults and what to do about them

Faults
Water is leaking out.
No water supply.
Detergent is not dis-
pensed.
Washing machine door
cannot be opened.
Programme does not
start.
Cause/remedial action
The washing machine door is unlocked. It is possible to add laundry.
Temperature too high. Wait until the temperature drops.
■
Water level too high. Not possible to add laundry. Close the washing machine
■
door immediately, if necessary. Select A Start/Reload to continue the pro-
gramme.
Wait until YES + ¼ light up.
■
Note: Do not open the washing machine door until both the symbols YES + ¼
■
light up.
Close the washing machine door properly; washing may be trapped.
Turn the water tap on fully,
■
Supply hose kinked or trapped,
■
Water pressure too low. Clean the filter. ~ Page 25
■
Detergent solution pump blocked. Clean the detergent solution pump.
■
~ Page 24
Drain hose/waste pipe blocked. Clean the drain hose on the siphon.
■
~ Page 25
Motor fault. Call the after-sales service. ~ Page 30
Water in the base trough, appliance leaking. Call the after-sales service.
~ Page 30
Childproof lock activated; deactivate it. ~ Page 19
Too much foam detected, a rinse cycle has been switched on ~ Page 20
Cause/remedial action
Attach/replace the drainage hose correctly.
■
Tighten the screw connection of the supply hose.
■
A Start/Reload not selected?
■
Tap not turned on?
■
Filter blocked? Clean the filter. ~ Page 25
■
Supply hose kinked or trapped?
■
Safety function active. Programme stopped? ~ Page 20
■
$ (without final spin) selected?
■
Can be opened by emergency release only? ~ Page 26
■
A Start/Reload or 5 Ready in -time selected?
■
Washing machine door closed?
■
E Childproof lock activated? Deactivate. ~ Page 19
■
Faults and what to do about them.
en
27