The Drain Hose At The Siphon Is Blocked; Filter In The Water Supply Blocked - Bosch WAE24461GB Series Instruction Manual And Installation Instructions
Hide thumbs
Also See for WAE24461GB Series:
Table of Contents
Advertisement
The drain hose at the siphon
is blocked
Switch off the appliance. Pull out the
1.
mains plug.
Loosen the hose clamp. Carefully
2.
remove the drain hose, residual
water may leak out.
Clean the drain hose and siphon
3.
connecting piece.
Reattach the drain hose and secure
4.
the connection point using the hose
clamp.
Filter in the water supply
blocked
:
Warning
Risk of electric shock!
Do not immerse the Aqua-Stop safety
valve in water (it contains an electric
valve).
For this, first reduce the water pressure
in the supply hose:
Turn off the water tap.
1.
Select any programme (except
2.
Rinse / Spin / Empty).
Press the Start/Reload button. Allow
3.
the programme to run for
approximately 40 seconds.
Turn the programme selector to Off.
4.
Pull out the mains plug.
Clean the filter on the water tap:
5.
Remove the hose from the water tap.
Clean the filter with a small brush.
Cleaning and maintenance
For standard and Aqua-Secure
6.
models, clean the filter on the rear of
the appliance:
Remove the hose from the rear of
the appliance.
Remove the filter using pliers and
clean the filter.
Connect the hose and check for
7.
leaks.
en
25
Advertisement
Table of Contents
