Maintenance - DeWalt DW433-XE Instruction Manual

MAINTENANCE

WARNING: WARNING: Turn off and unplug sander before making any adjustments or removing or
installing accessories. Before reconnecting the tool, depress and release the trigger switch
to ensure that the tool is off.
TO REMOVE THE BRUSHES
The brushes on your belt sander may require replacement at some point during the life of the
tool. Contact your local D W W WALT W ALT ALT authorized service centre to obtain additional brushes. ALT authorized service centre to obtain additional brushes.
E E E
1. To remove the brush cover (FIG.1(C), use a flat head screwdriver or a T20 TorxBit
2. Remove the brushes.
TO INSTALL A NEW PLATEN/CORK ON YOUR BELT SANDER
The cork under the platen on your belt sander may require replacement at some point during
the life of the tool. A new platen/cork is available through your D
1. Remove the sanding belt from the sander as described in Assembly.
2. Use an M3 hex wrench to remove the existing steel platen/cork on the underside of
the unit.
3. Attach the new platen/cork to the sander and discard the old one.
4. Install a sanding belt as described in Assembly.
LUBRICATION
Your tool was properly lubricated before leaving the factory. In from two to six months,
depending upon use, take or send your tool to a Service Centre, or authorized service
centre, for a complete cleaning, inspection and lubrication. Tools used constantly on
production jobs will need re lubrication more often. Also, tools "out of service" for long
periods should be re lubricated before being put back to work.
D WALT AFTER SALES SERVICE
E
All D WALT power tools are thoroughly tested before leaving the factory. However, if the
E
power tool needs repair, please contact your dealer or take it to your nearest D
Service Centre. There is a Service Centre in every capital city. For service, repair or parts call
1800 654 155.
ACCESSORIES
Recommended accessories for use with your tool are available at extra cost from your local
service centre. Call 1800 654 155 (Aust) or 09 526 2556 (NZ).
ELECTRICAL SAFETY
The electric motor has been designed for one voltage only. Always check that the power
supply corresponds to the voltage on the rating plate. Your D
therefore no earth wire is required.
.
EXTENSION CORDS
using extension cords, inspect it for loose or exposed wires, damaged insulation and
W W WALT W ALT service centre. ALT ALT service centre.
E E E
defective fittings. Replace the cord if necessary.
WALT
E
8
CAUTION: The use of any non-recommended accessory may be hazardous.
CAUTION: Use only extension cords that are approved and marked accordingly. Before
WALT tool is double insulated,
E