General; System Set-Up - Kenwood TK-3212L Service Manual

TK-3212L
DOCUMENT COPYRIGHTS
Copyright 2007 by Kenwood Corporation. All rights
reserved.
No part of this manual may be reproduced, translated,
distributed, or transmitted in any form or by any means,
electronic, mechanical, photocopying, recording, or other-
wise, for any purpose without the prior written permission
of Kenwood.
DISCLAIMER
While every precaution has been taken in the preparation
of this manual, Kenwood assumes no responsibility for
errors or omissions. Neither is any liability assumed for dam-
ages resulting from the use of the information contained
herein. Kenwood reserves the right to make changes to any
products herein at any time for improvement purposes.
INTRODUCTION
SCOPE OF THIS MANUAL
This manual is intended for use by experienced technicians
f a m i l i a r w i t h s i m i l a r t y p e s o f c o m m e r c i a l g r a d e
communications equipment. It contains all required service
information for the equipment and is current as of the
publication date. Changes which may occur after publication
are covered by either Service Bulletins or Manual Revisions.
These are issued as required.

SYSTEM SET-UP

Merchandise received
License and frequency allocated by FCC
Choose the type of transceiver
Transceiver programming
Are you using the optional antenna?
Are you using the speaker microphone?
2
GENERAL / SYSTEM SET-UP
A personal computer (IBM PC or compatible), programming
interface (KPG-22/22A), USB adapter (KCT-53U), and programming
software (KPG-100D) are required for programming.
(The frequency, TX power HI/LOW, and signaling data are programmed
for the transceiver.)
YES
NO
YES
NO
Delivery
ORDERING REPLACEMENT PARTS
When ordering replacement parts or equipment information,
the full part identification number should be included. This
applies to all parts, components, kits, or chassis. If the part
number is not known, include the chassis or kit number of
which it is a part, and a sufficient description of the required
component for proper identification.
PERSONAL SAFETY
The following precautions are recommended for personal
safety:
● DO NOT transmit until all RF connectors are verified secure
and any open connectors are properly terminated.
● SHUT OFF and DO NOT operate this equipment near
electrical blasting caps or in an explosive atmosphere.
● This equipment should be serviced by a qualified technician only.
SERVICE
This transceiver is designed for easy servicing. Refer to
the schematic diagrams, printed circuit board views, and
alignment procedures contained within.
Unit
Model TX-RX Unit
& destination
TK-3212L K,M X57-7130-12
K2,
TK-3212L X57-7130-13
M2
Frequency range (MHz) RF power
TX/RX 450~490
TX/RX 470~512
KRA-23 or KRA-27
Optional antenna
(Option)
KMC-17 or KMC-21
Speaker microphone
(Option)
Frequency range
450~490MHz
IF1 : 38.85MHz
LOC : 38.4MHz
470~512MHz
Type
4.0W TK-3212L (K,M)
4.0W TK-3212L (K2,M2)
Remarks