Advertisement
KV-ES29M31/ES29M61
RM-916
4-2. CONVERGENCE ADJUSTMENT
Preparation :
•
Before starting this adjustment, adjust the focus, horizontal size
and vertical size.
•
Set the PICTURE 70% and BRIGHTNESS 0%.
•
Cross hatch / Dot pattern.
(1) Horizontal and Vertical Static Convergence
Center dot
R
G
B
H. STAT VR
1. (Moving horizontally), adjust the H.STAT control so that the
red, green and blue dots are on top of each other at the center of
the screen.
2. (Moving vertically), adjust the V.STAT magnet so that the red,
green and blue dots are on top of each other at the center of the
screen.
3. Adjust Horizontal Trapezoid with "DAC 04 HTR" in Service
Mode to make H-Trapezoid distortion best.
4. If the H.STAT variable resistor cannot bring the red, green and
blue dots together at the center of the screen, adjust the
horizontal convergence with the H.STAT variable resistor and
the V.STAT magnet in the manner given below.
(In this case, the H.STAT variable resistor and the V.STAT
magnet influence each other, so be sure to perform adjustments
while tracking.)
http://cxema.ru
R
G
B
V. STAT
Magnet
Y magnet
RV702
H. STAT
C Board
1
V. STAT
a
b
b
2
H. STAT VR
a
R
G
B
b
B
G
R
3
b
a
R
b
Purity
– 42 –
a
b
B
B
G
G
R
R
a
b
B
G
G
R
B
BMC (Hexapole)
V.STAT
Advertisement
