Ace Nstallation; Urround Anels Nstallation - Lennox Hearth Products Designer DBV Installation And Operation Manual

s p i
urround anels nstallation
The Designer™ insert surround panels are made of heavy gage
steel for durability and, if desired, for the ease of making an inside
fit in the fireplace. See "Packaging List" for sizes available.
1. Remove the speed nuts from the parts bag and install (with the
flat surface forward) on the six holes in the surround brackets,
three on each side of the insert (See A in Figure 14). A flat
bladed screwdriver may help in installing the nuts.
2. Install all surround panels and trim with the insert positioned
in the fireplace but a few inches in front of its final location.
3. If the insert face is to be installed on the insert, the sight
obstructor that comes with the face must be installed prior
to installing the surround panels. With the curved edge down
and the bent top edge positioned toward the insert, slide the
tabs at the ends of the obstructor in the slots on the surround
brackets (see C in Figure 14).
4. Install the side surround panels by lining up the holes in the
tabs on the side surround panels in front of the holes on the
surround brackets. Next insert two slotted 1/4" truss screws
for each side surround panel and secure loosely.
5. Fasten top surround panel with the remaining two truss screws.
Tighten all six truss screws after adjusting the surround panels
to eliminate space between side and top surround panels.
6. Assemble the surround trim by inserting the elbowed retainer in
the rectangular slot in the ends of the longest piece of trim and
secure by tightening the screw in the retainer. Slide the mitred
ends of the two side trim pieces onto the elbowed retainer and
secure by tightening the retainer screw.
7. The fastened trim pieces should now be horseshoe shaped.
Slide the trim down over the surround panels so the edge of
the surround panel fits just behind the rounded edge of the
trim.
8. Install three spring clips (found in parts bag in firebox) in each
piece of trim by inserting them between the rear of the surround
and the channel of the trim. The spring clips will push the trim
tight to the surround.
C
Figure 14
f i
aCe
A number of different face finishes and shapes are avail-
able for your Designer™ Flush Gas Insert. The insert Face
comes with a sight obstructor that must be installed prior
to installing the surround panels (see step 3 on Page 11)
and face. The faces come with hooked brackets. To install
the face, hang the hooked bracket on the surround brackets
(D in Figure 14).
NOTE: GOLD PLATED SURFACE MUST BE CLEANED
WITH GLASS CLEANER AND SOFT RAG BEFORE FIRING
THE FIRST TIME OR FINGER PRINTS AND STAINS WILL
REMAIN PERMANENTLY. NEVER USE BRASS POLISH TO
CLEAN GOLD, THIS WILL REMOVE GOLD PLATING!
ORIFICE SIZE/ALTITUDE ADJUSTMENT
See instructions on page 4
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
C
nstallation and leaning
A
B
11