Lenovo ThinkPad Yoga 260 User Manual page 63

Installing or removing a smart card
Attention: Before installing or removing a smart card, ensure that you observe the following precautions:
• Before you start, read "Static electricity prevention" on page 119.
• When data is being transferred, do not put your computer into sleep or hibernation mode and do not
perform any installation or removal actions. Otherwise, your data could get damaged.
• Do not remove a smart card while the computer is in sleep or hibernation mode. Otherwise, the system
might not respond when you try to resume operation.
To install a smart card: Hold the smart card in correct orientation and then insert it firmly into the slot in
the smart card reader.
To remove a smart card: Exit all programs that are working with the smart card first. Otherwise, data
on the smart card might get damaged or lost. Pull the smart card outward a little bit and then slide it
completely out of the slot.
After you install a smart card, do the following to enable the plug-and-play feature for the smart card:
1. Open Control Panel, and ensure that you view Control Panel by Category.
2. Click Hardware and Sound.
3. Click Device Manager. If you are prompted for an administrator password or confirmation, type the
password or provide confirmation.
4. From the Action menu, select Add legacy hardware. The Add Hardware Wizard starts.
5. Follow the instructions on the screen.
.
Chapter 2 Using your computer
47