Oven Light; Storage - Rangemaster Elite SE 110 User's Manual & Installation Instructions

Fig. 2.24
Left-hand side
Fig. 2.25
Left-hand side
Fig. 2.26
Right-hand side
Right-hand side
10
Other Uses
The Handygrill and pan can also be used for roasting.
Remove the trivet from the pan and position the rack at the
height of the centre of the oven. Use the fan or conventional
oven settings and follow the guide time in the cooking chart
for roasting.
Only use the supplied pan in the Handygrill rack – any other
vessel could be unstable.
Fitting the Handygrill
Line up the ends of the Handygrill rack with a pair of holes in
the mounting brackets on the oven door (Fig. 2.24).
Slide the ends into both uprights at the same time (Fig. 2.25).
Hook the rack on to the uprights.

Oven Light

The oven light comes on as soon as the thermostat is turned
on.
If the oven light fails, turn off the power supply before
changing the bulb. See the 'Troubleshooting' section for
details on how to change the bulb.

Storage

The bottom drawer is for storing oven trays and other
cooking utensils.
It can get very warm, so do not store anything in it that may
melt or catch fire. Never store flammable materials in the
drawer. This includes paper, plastic and cloth items, such as
cookbooks, plastic ware and towels, as well as flammable
liquids. Do not store explosives, such as aerosol cans, on or
near the appliance.
The drawer can be removed completely for cleaning, etc.
To Remove the Storage Drawer
1. Note: To avoid exterior damage to the Storage Drawer.
Ensure a soft cushioned mat is placed on the floor and
covers the width and depth of the Storage Drawer.
2. Slide the Storage Drawer out until it stops.
3. Unscrew the two fasteners and remove the screw
washers from either side of the Storage Drawer runner
brackets (Fig. 2.26).
To Fit the Storage Drawer
1. Note: To avoid exterior damage to the Storage Drawer.
Ensure a soft cushioned mat is placed on the floor and
covers the width and depth of the Storage Drawer.
2. Align the two holes on either side of the Storage Drawer
with the runner brackets (Fig. 2.26).
3. Fasten the two fasteners and screws washers on either
side of the Storage Drawer.
4. Close drawer and check the alignment and adjust Storage
Drawer position accordinally.
5. Check the alignment is correct and ensure all fasteners
are fully tightened.