JVC KD-S747 Service Manual page 6

KD-S747
2.1.5 Removing the rear bracket
(See Fig.7)
• Prior to performing the following procedure, remove the front
panel assembly, front chassis assembly, heat sink and bottom
cover.
(1) Remove the three screws D, screw E and two screws F on
the back of the body.
(2) Remove the rear bracket.
2.1.6 Removing the main board
(See Fig.8)
• Prior to performing the following procedure, remove the front
panel assembly, front chassis assembly, heat sink, bottom
cover and rear bracket.
(1) Remove the two screws G attaching the main board.
(2) Disconnect connector CN501 and remove the main board.
2.1.7 Removing the CD mechanism assembly
(See Fig.9)
• Prior to performing the following procedure, remove the front
panel assembly,front chassis assembly, heat sink, bottom cov-
er, rear bracket and main board.
(1) Remove the three screws H .
1-6 (No.49822)
Rear bracket
D
Fig.7
Main board
G
CN501
Fig.8
CD mechanism assembly
Fig.9
F
E
D
G
H
Top chassis
H