Mounting the Bar and Chain
Models with Quick Chain Tensioner
3
You can run chains of different pitches
on this chainsaw - depending on the
chain sprocket (see "Specifications")
The chain pitch must match the guide
bar. In addition, the drive link gauge
must match the guide bar groove width.
• • • •
Pull out the hinged handle (1) of the
wingnut so that it snaps into posi-
tion.
• • • •
Turn the wingnut (2) counterclock-
wise until it hangs loose in the chain
sprocket cover (3).
• • • •
Remove the sprocket cover.
26
1
2
• • • •
Remove the tensioning gear (4)
and turn it over.
• • • •
Take out the screw (5).
4
5
6
8
• • • •
Position the tensioning gear (6)
against the guide bar (7).
• • • •
Fit and tighten down the screw (8).
7
017, 018