Fanimation The Stafford PL8274 Owner's Manual page 12

How to Assemble the Blades and Light Kit
3. Remove one of the three screws in the support
bracket at the bottom of the motor assembly.
Slightly loosen the remaining two screws and
retain the removed screw (Figure 3).
4. Connect the black wire from the socket plate
assembly to the black wire from the motor assembly,
and the white wire from the socket plate assembly
to the white wire from the motor assembly (Figure 4).
5. Assemble the socket plate assembly to the motor
assembly using the two key slots. Replace the
previously removed screw and securely tighten all
three screws (Figure 5).
6. Remove one of the three screws in the socket
plate assembly. Slightly loosen the remaining
two screws. Assemble the light plate assembly
to the socket plate assembly using the two key
slots in light plate assembly. Replace the third
screw and securely tighten (Figure 6).
Motor
Assembly
Motor Assembly
Single Pin Connector
Socket Plate
Single Pin Connector
Screws (3)
12
Figure 3
Socket Plate
Assembly
Figure 4
Socket Plate
Assembly
Figure 5
Socket Plate
Assembly
Light Plate
Assembly
Figure 6