Kohler command cv17 Service Manual page 57

Pawls (dogs) Replacement
1. Install a clamp to hold pulley in starter housing and
prevent if from rotating.
2. Remove center screw, washer, and pawl retainer.
3. Note position of pawls and pawl springs before
removing. Remove pawls, pawls springs, brake
spring and brake washer from pulley.
4. Clean/wipe out center pocket of pulley to remove
any accumulated dirt and old lubricant.
5. Apply small amount of grease to new brake washer
and spring, install them in center pocket.
6. Install pawl springs and pawls into pawl slots of
pulley. All parts must be dry.
7. Position drive plate over pawls with actuating ears
down and inside of pawls.
8. Apply a small amount of Loctite
center screw. Install center screw with washer.
Torque screw to 7.4-8.5 N·m (65-75 in. lb.).
9. Remove clamp and pull starter rope out part way to
check operation of pawls.
Install Starter
1. Install retractable starter onto blower housing leaving
screws slightly loose.
2. Pull starter handle out until pawls engage in drive
cup. Hold handle in this position and tighten screws
securely.
24 690 07 Rev. H
271™ to threads of
®
KohlerEngines.com
Starter System
57