Table of Contents
Advertisement
Rear baffle removal
NOTE: The rear baffle comes complete with the rear grass door.
Screws
Lower belt cover
Figure 4.57
Transmission removed
Figure 4.58
Figure 4.59
1.
Allow the engine to cool, then disconnect and ground
the spark plug wire.
2.
Confirm the the fuel level is low enogh that there is no
risk of spillage.
3.
Tip the mower back on its handlebars, or on its side
with the air filter up, so that the lower belt cover can
be reached.
4.
Remove the screws that fasten the lower belt cover
to the mower deck using a 3/8" wrench. The belt
cover can remain in place. See Figure 4.57.
5.
Remove the transmission as described previously in
this chapter. See Figure 4.58.
6.
Carefully tip the mower down so that it is resting with
the bottom of the deck on the workbench.
7.
Remove the handlebars as described in a previous
section of this chapter. See Figure 4.59.
Deck and Transmission
49
Advertisement
Table of Contents
