Chapter 1: Introduction; About The Text Format - MTD C series Shop Manual

Table of Contents

Professional Service Manual Intent: This manual is intended to provide service dealers with repair and overhaul

procedures for the "C" and "D" series mowers.

Disclaimer: The information contained in this manual is correct at the time of writing. Both the product and the infor-

mation about the product are subject to change without notice.

Certain flags and key words are used to indicate the nature of the text that accompanies them. They are as follows:

! CAUTION

! WARNING

! DANGER

NOTE: "NOTE" is used to point-out helpful information that may not fit as a step in a procedure.

Numbered steps indicate specific things that should be done, and the order in which they should be done.

1a. Sub steps will be lettered and nested within steps. Two or more sub steps may be combined to describe

the actions required to complete a step.

•

Bullet points: Indicate sub-steps or points of interest, without implying order or relative importance.

Disclaimer: This manual is intended for use by trained, professional technicians.

•

Common sense in operation and safety is assumed.

•

In no event shall MTD be liable for poor text interpretation, or poor execution of the procedures described

in the text.

•

If the person using this manual is uncomfortable with any procedures they encounter, they should seek

the help of a qualified technician.

CHAPTER 1: INTRODUCTION

Indicates a potentially hazardous situation that, if not avoided, may result in minor or

moderate injury. It may also be used to alert against unsafe practices.

Indicates a potentially hazardous situation that, if not avoided, could result in death or

serious injury.

Indicates an imminently hazardous situation that, if not avoided, will result in death or

serious injury. This signal word is to be limited to the most extreme situations.

Introduction

Table of Contents

D series