Installing The System Board - Dell Vostro 3560 Owner's Manual

4. Remove the:
• heat sink assembly
• processor
• PCIe expansion card
• memory module
• WLAN card
5. Disconnect all the cables from the connectors on the system board.
6. To remove the system board:
a. Remove the screws that secure the system board to the computer [1].
b. Slide the system board toward the front of the computer and lift it away from the computer [2].

Installing the system board

1. Hold the system board by its edges and angle it toward the back of the computer.
2. Lower the system board into the computer until the connectors at the back of the system board
align with the slots on the back wall of the computer, and the screw holes on the system board align
with the standoffs on the computer.
3. Tighten the screws to secure the system board to the computer.
4. Route all the cables through the routing channels and connect all the cables to the connectors on
the system board.
5. Install the:
• WLAN card
• memory module
• PCIe expansion card
• processor
• heat sink assembly
6. Close the front bezel door.
7. Install the:
• bezel
• cover
8. Follow the procedure in After Working Inside Your Computer.
21