4. Connect the water tap adaptor and water supply hose.
Screw
thread
Lever
Elbow
Nut
Water supply
valve screw
5. Connect the power plug and grounding wire.
● Ask a service person for grounding work.
● In case of 2 pin power cords, establish a ground.
■
Adjusting height with the adjustable leg knob.
1) Turn the adjustable leg knob to the left side and loosen
as indicated with the left pointing arrow. Then, turn the
adjustable leg to adjust the levelness.
2) Turn the adjustable leg knob to the right side and
tighten securely as indicated with the right pointing
arrow.
Loosen
Adjustable leg
To raise
● Check if there is no water leakage, abnormal sound or error messages.
NA-F75B3_マレーシア向洗濯機.indd 13
NA-F75B3_マレーシア向洗濯機.indd 13
Connect the water tap adaptor
1
to the faucet.
A part
1) Loosen 4 screws.
2) Connect to the faucet and tighten the
screws.
Fix.
2
● Turn A part to the right side and
tighten securely.
(To prevent water leak)
Connect the water supply hose
3
to the water tap adaptor.
● Pushing down the lever, insert and hook
the claw of the lever on the fl ange of the
adaptor.
Connect the water supply hose
4
to the water supply valve screw.
● Slightly lift up the elbow and tighten the
nut.
● Check if the elbow is not loose.
6. Check the horizontal state.
Tighten
Adjustable leg
knob
To lower
7. Perform a trial operation.
Flange
Claw
Lever
NOTE
● When reconnecting the water tap
adaptor, turn A part to the left until
4 mm of screw thread become
visible. Then, do the procedure.
CAUTION
● Tighten the nut fi rmly.
(To prevent water leak)
● Do not forcibly bend the water
supply hose.
(To prevent water leak caused by
the bent hose)
13
13
2013/02/18 16:02:36
2013/02/18 16:02:36