Installation
1. Check the installation location.
■
Avoid the following locations for installation.
• Locations where there is a possibility of freezing.
• Locations exposed to direct sunlight
(To prevent malfunction or deformation)
• Uneven or unstable locations
(on blocks, timbers, table with wheels attached, etc.)
NOTE
● Do not block the opening of the bottom face with carpet, etc.
2. Attach the bottom cover.
Preparation: Set a cardboard, etc. and lay the washing machine on it, avoiding
product damage and deformation. (Face the front side down.)
1
Insert the bottom cover with its screw hole set
at the bottom.
2
Set 6 holes to the corresponding projections
and fi x with one screw.
Projection
1
Connect to the
connection port.
Hose band
External drain water hose
Main unit rear side
● Insert all the way seated.
12
12
NA-F75B3_マレーシア向洗濯機.indd 12
NA-F75B3_マレーシア向洗濯機.indd 12
■
If the installation, test run and inspection of the washing machine are not
carried out following this installation method, Panasonic will not be liable
for any accident or damage caused.
■
Make sure to ask a service person for installation. Do not install by yourself.
Screw hole
Screw hole
3. Attach the external drain water hose.
2
Slide the hose
band in the arrow
direction.
Hose band
Water tap adaptor
(Bottom face)
■
Hose arrangement
● Do not put the hose tip
under the water.
● The height should be
10 cm or less.
● The extension length
should be 3 m or less.
Water supply
hose
Water
supply
valve
screw
NG
10 cm
or less
3 m or less
2013/02/18 16:02:36
2013/02/18 16:02:36