Troubleshooting - Manta DVBT03 User Manual

− Press the UP or DOWN button to move the cursor to
set Start date, Star time and End time.
− After Star date, Start time and End time are set, please
set the mode to Record. Press the
− OK button on the remote control to confirm.
− After all the setting are confirmed, this screen will
appear.
− Press EXIT button on the remote control to watch TV
program.
− Time shift
− If you are watching live tv and want to pause it until you
return then do the following.
− Please connect a USB mass storage device with the
set top box.
− Please press REC button on the remote control, the
recording icon will display at the top
− Press PLAY button on the remote control, a bar will ap-
pear at the bottom of the screen. Slect REC to review,
or FWD or forward.
− Press EXIT button on the remote control to go back to
watch normal TV

Troubleshooting

PROBLEM
No picture
Screen Shows
„No Signal„
No sound from speaker
Only sound, no Image
on the screen
Remote control is not
workable
The image stop
Suddenly or mosaic
USER'S MANUAL
POTENTIAL REASONS
Power isn't connected
The power switch is not on
Not connect DVB-T cable
Incorrect setting
No or incorrect connection with audio cable
Mute the sound
Incorrect sound track
No or incorrect connection with AV cable
Program is a radio program
The battery is exhausted
Remote control unit is not in the right opposite of
the front panel or too far from it
The signal i too weak
WHAT TO DO
Connect the power
Switch on the power
Plug in the DVB-T cable
Set up correct parameter
Connect the audio cable correctly
Switch on the correct, wolume control
Try another sound track
Connect the video calbe correctly
Press TV/RADIO key to shift into TV
mode
Change new battery
Adjust the way of holding remote control
unit and get near to the panel
Strengthen the signal
27