TP-Link HS100 User Manual page 10

National Restrictions
This device is intended for home and office use in all EU countries (and other countries following the EU directive
1999/5/EC) without any limitation except for the countries mentioned below:
Country Restriction
Belarus Not implemented
Norway Implemented
Italy Implemented
Russian Limited
Federation implementation
Ukraine Limited
implementation
ATTENTION: Due to EU law, the country settings must be identical to the country where the device is operating
(important due to non-harmonised frequencies in the EU).
Canadian Compliance Statement
This device complies with Industry Canada license-exempt RSSs. Operation is subject to the following two conditions:
1） This device may not cause interference, and
2） This device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes :
Reason/remark
This subsection does not apply for the geographical area within a radius of 20 km
from the centre of Ny-Ålesund on Svalbard.
The public use is subject to general authorisation by the respective service
provider.
1. SRD with FHSS modulation
1.1. Maximum 2.5 mW e.i.r.p.
1.2. Maximum 100 mW e.i.r.p. Permitted for use SRD for outdoor applications
without restriction on installation height only for purposes of gathering telemetry
information for automated monitoring and resources accounting systems.
Permitted to use SRD for other purposes for outdoor applications only when the
installation height is not exceeding 10 m above the ground surface.
1.3. Maximum 100 mW e.i.r.p. Indoor applications.
2. SRD with DSSS and other than FHSS wideband modulation
2.1. Maximum mean e.i.r.p. density is 2 mW/MHz. Maximum 100 mW e.i.r.p.
2.2. Maximum mean e.i.r.p. density is 20 mW/MHz. Maximum 100 mW e.i.r.p. It is
permitted to use SRD for outdoor applications only for purposes of gathering
telemetry information for automated monitoring and resources accounting
systems or security systems.
2.3. Maximum mean e.i.r.p. density is 10 mW/MHz. Maximum 100 mW e.i.r.p.
Indoor applications.
e.i.r.p. -in antenna with amplification factor up to 6 dBi.
≤100 m W w i th bui l t