Download Print this page

Display & Button Functions - Benefit B425 91105 Assembly Instructions Manual

Advertisement

As soon as user install batteries, computer will power on and LCD full display all segments
then enter into the SCAN function mode after one second. Press the MODE key to select
function.
When there is pedaling signal transmitted to the console without pressing any key, console
starts
to work, all function TMR/SPD/DST/CAL will start to count up automatically.
If no buttons are pressed and the pedals have not been moved for 4 minutes, the computer
will switch to Idle mode.
【DISPLAY & BUTTON FUNCTIONS】
Training Values
TIME
SPEED
DISTANCE
CALORIES
PULSE
BUTTON
-Confirm setting
-Select function
MODE
-Clear all values and reboot computer if hold on for 3 seconds
-To enter into selected function
SET
-To adjust TIME/ DISTANCE/CALORIES value up when stop exercising
-Hold on this button will increase values fast as Hot key.
-After stop exercising for 4 seconds, press it to clear all values to 0 except
RESET
SCAN & SPEED.
-Hold on for 3 seconds to reboot the computer.
Training Data
The computer calculates and displays all values automatically according to user training
status.
Operation Instruction
Press MODE button to select function to be set, the following function will be display in
sequence:
SCAN TMR
SPEED
* TMR – Press the SET key to set target exercise time, each time it will increase by 1:00; If
TIME
counts down to 0:00 from target value, computer will stop work and 0:00 is
flashing for
0:00.
* SPD – This function cannot be preset. When user start to pedal with bike, LCD will display
current exercising speed.
* DST - Press SET key to set target exercise Distance, each time it will increase by 1.0 m. If
DISTANCE counts down to 0.0 from target value, console will stop work and 0.0 is flashing
for reminder, press any key to stop it. Then DISTANCE will start to count up.
Display Range
00:00 ~99:59 min.
0 ~999.9 KM
0~999.9 KM
0~999.9 Cal
30~230 bpm
DIST CAL
reminder, press any key to stop it. Then TIME will start to count up from
FUNCTION
PUL SCAN.
13
Setting Range
0:00~99:00 min.
/
0:00~999.0 KM
0~999.0 Cal
0-30~230 bpm

Advertisement

loading