Charmglow HBL-15SDLP User Manual page 13

SE-300270 Adirondack IM R4.qxp:Adirondack manual
SECTION 6
Problem
Excessive noise in
the lower portion of
the heater.
Heater system
doesn't come on.
"HEATER POWER"
switch has been
flipped in the on
position, but there is
no airflow.
4/13/07 5:19 PM
Cause
Flame element isn't seated
properly.
Motor is defective.
Heater power switch is off.
Thermostat is set too low.
Heater system is overheated.
Loose wiring.
The air inlet or air outlet is
blocked completely.
The heater system is overheated.
Temperature Limit thermostat
is cut off.
Fan motor is defective.
Fan blower is unbalanced.
13
Page 13
TROUBLESHOOTING
Solution
Call customer service
1-800-890-4076.
Call customer service
1-800-890-4076.
Turn the heater power switch to the
"ON" position.
Move the thermostat slide to a
higher setting.
The heater is covered or air inlet or
air outlet are blocked; remove the
cloth or the blockage and turn off
the power switch and unplug it.
Wait five minutes, then turn the
heater on again.
Check all wiring for loose
connections. Contact a
qualified electrician.
Move the unit, make sure to leave
adequate space around the unit.
Remove the blockage, on or in front
of the air outlet.
Check the air inlet and outlet.
Turn off the power switch and
unplug it. Wait five minutes, then
turn the heater on again.
Call customer service
1-800-890-4076.
Call customer service
1-800-890-4076.