Heater Operation - Charmglow HBL-15SDLP User Manual

SE-300270 Adirondack IM R4.qxp:Adirondack manual
OPERATING INSTRUCTIONS
4.2 CONTROL PANEL OPERATING PROCEDURES (CONTINUED)
Flame Operation:
1. To switch on the flame, flip the "FLAME POWER" rocker switch to on. The red LED
light on the switch turns on.
2. To adjust the brightness of the flame, turn the right-hand dial clockwise, marked
"FLAME", until it reaches the brightness you desire.

Heater Operation:

1. To switch on the heater, flip the "FAN POWER" rocker switch on. The red LED
light turns on.
2. Flip the second rocker switch from the left, marked "Heater I". This switch gives
you approximately 750W of power to your heater. This switch is for low-level
heating. For high-level heating, make sure that the "FAN POWER", "HEATER I" and
"HEATER II" switches are all turned on.
3. To adjust the temperature, turn the left-hand dial clockwise, marked
"TEMPERATURE CONTROL" until it reaches the temperature you desire.
4/13/07 5:19 PM Page 10
10
SECTION 4
FLAME
Fig. 6
TEMPERATURE
CONTROL
Fig. 7