Table of Contents
Advertisement
ROAMING AND SYSTEM OPERATION
System Type Selection
If home system is wireline (type B)
Flashing RM (Roam) indicator = call on A system
Slow flashing RM (Roam) indicator = call on home
type system
Slow flashing IU (In Use) indicator = call on
home system
Home Only Mode
Phone will not operate outside its home system.
Scan A Mode
Phone will operate only within non-wireline
(A) systems.
Scan B Mode
Phone will operate only within wireline
(B) systems.
Enter SID Mode (Available in some models only) PREF / D SiDS
Unit will operate only within specifically
identified systems. This choice requires entry of
up to 15 System ID numbers for those systems
over which you wish to operate. The SID digits
are entered as obtained from your Cellular
Service Operator. When Preferred SIDS is
enabled, C Scan Mode is disabled. See page 50.
The choice of System Type, as described on page 48, may be
selected or canceled as follows:
1. Press ‰, •. The display shows the current active choice.
Repeatedly press • until the desired System Type appears
in the display.
2. If you chose Preferred SIDS, press Ø and then enter the
five-digit number at this time. Use • and £ to move to
the next SID location.
3. To activate the selection, press Ø.
4. To return to normal operation, press ´.
C h a n g i n g S y s t e m T y p e
49
Display
SCAN AB
XOME
SCAN A
SCAN B
Advertisement
Table of Contents
