Table of Contents
Advertisement
ROAMING AND SYSTEM OPERATION
Contact your system operator, or that of the visited system, for informa-
tion on dialing and billing procedures.
To use alternate long distance services when roaming, be certain to dial
the appropriate area code and local number to access the alternate car-
rier in the visited area. Then use the Tone Dialing sequence described on
page 26. If you selected Two-System Operation (see page 21) enter ‰,
£ to verify the currently active number. This is especially important if
your two home systems have different area codes, or if RM (Roam) is
flashing within home service area.
S e l e c t a b l e S y s t e m R e g i s t r a t i o n
To Review Current Setting:
1. Press ‰, •.
The display will show the current active system choice.
2. Repeatedly press • to review the System Type modes.
(Press ´ to exit without changing selections.)
3. Press Ø to activate the displayed selection.
System Type Selection
C Scan
When programmed, this is the default setting.
Standard Mode
Your phone first seeks a home type system, then
a non-home type.
If home system is non-wireline (type A)
If home system is wireline (type B)
Invert Preference Mode
Your phone first seeks a non-home type system,
then home type. (Select this mode if in a fringe
area of your home system or in certain
roaming situations.)
If home system is non-wireline (type A)
Fast flashing RM (Roam) indicator = call on B system
Slow flashing RM (Roam) indicator = call on home
type system
Slow flashing IU (In Use) indicator = call on
home system
48
Display
CSCAN
STD AB
STD BA
SCAN BA
Advertisement
Table of Contents
