Jp1: Clear Cmos Contents; Jp2: Watchdog Timer Settings; Jp4: Compact Flash Slave/Master - IBT MB875 User Manual

INSTALLATIONS

JP1: Clear CMOS Contents

Use JP1 to clear the CMOS contents. Note that the ATX-power
connector should be disconnected from the board before clearing
CMOS.
JP1

JP2: Watchdog Timer Settings

JP2 Setting
Pin 1-3 & 2-4
Short
Pin 1/2/3/4
Open
Pin 1-2 & 3-4
Short
Jumper
1-2, 3-4 Open
*
1-2, 3-4 Short

JP4: Compact Flash Slave/Master

10
Setting
Pin 1-2
Short/Closed
Pin 2-3
Short/Closed
Ethernet default: Eth0 & Eth1 None Bypass.
System will bypass
of Watchdog timer
Ethernet default: Eth0 & Eth1 Bypass mode.
System will not bypass
timeout of Watchdog timer
System will reboot
Watchdog timer. (Default)
Function
System wi ll bypass LANs upon the ti m eout of WDT tim er
System wi ll reboot upon the ti m eout of WDT tim er
JP4 Compact Flash
Open
Close
MB890 User's Manual
Function
Normal
Clear CMOS
Function
LANs upon the timeout
LANs upon the
upon the timeout of
Slave
Master