Table of Contents
Advertisement
Installing the Memory
The MB875 board supports one DDR memory sockets for a maximum
total memory of 1GB in DDR memory type. The memory module
capacities supported are 128MB, 256MB, 512MB and 1GB. The
following table lists the supported DDR DIMM configurations. Intel
852GM supports configurations defined in the JEDEC DDR DIMM
specification only. Non-JEDEC standard DIMMs such as double-sided
x16 DDR SDRAM DIMMs are not supported.
Installing and Removing Memory Modules
To install the DDR modules, locate the memory slot on the board and
perform the following steps:
1. Hold the DDR module so that the key of the DDR module align with
those on the memory slot.
2. Gently push the DDR module in an upright position until the clips of
the slot close to hold the DDR module in place when the DDR module
touches the bottom of the slot.
3. To remove the DDR module, press the clips with both hands.
Lock
Lock
DDR Module
MB890 User's Manual
INSTALLATIONS
Lock
Lock
®
7
Advertisement
Chapters
Table of Contents
