Setting The Am Tuning Step; Switching The Warning Tone; Switching The Auxiliary Setting; Switching The Dimmer Setting - Pioneer DEH-P1Y Operation Manual

Section
11 Initial Settings
1 Use Multi-Control to select FM Step.
FM Step appears in the display.
2 Press Multi-Control to select the FM
tuning step.
Pressing Multi-Control repeatedly will switch
the FM tuning step between 50 kHz and 100
kHz. The selected FM tuning step will appear
in the display.
Note
If seek tuning is performed in 50 kHz steps, sta-
tions may be tuned in imprecisely. Tune in the sta-
tions with manual tuning or use seek tuning
again.

Setting the AM tuning step

The AM tuning step can be switched between
9 kHz, the preset step, and 10 kHz. When
using the tuner in North, Central or South
America, reset the tuning step from 9 kHz (531
 1,602 kHz allowable) to 10 kHz (530  1,640
kHz allowable).
1 Use Multi-Control to select AM Step.
AM Step appears in the display.
2 Press Multi-Control to select the AM
tuning step.
Pressing Multi-Control repeatedly will switch
the AM tuning step between 9 kHz and 10 kHz.
The selected AM tuning step will appear in the
display.

Switching the warning tone

If the front panel is not detached from the
head unit within four seconds of turning off
the ignition, a warning tone will sound. You
can turn off the warning tone.
50
En
1 Use Multi-Control to select Warning.
Warning appears in the display.
2 Press Multi-Control to turn warning
tone on.
Warning :ON appears in the display.
# To turn warning tone off, press Multi-Control
again.

Switching the auxiliary setting

It is possible to use auxiliary equipment with
this unit. Activate the auxiliary setting when
using auxiliary equipment connected to this
unit.
1 Use Multi-Control to select AUX.
AUX appears in the display.
2 Press Multi-Control to turn AUX on.
AUX :ON appears in the display.
# To turn AUX off, press Multi-Control again.

Switching the dimmer setting

To prevent the display from being too bright at
night, the display is automatically dimmed
when the cars headlights are turned on. You
can turn the dimmer on or off.
1 Use Multi-Control to select Dimmer.
Dimmer appears in the display.
2 Press Multi-Control to turn dimmer on.
Dimmer :ON appears in the display.
# To turn dimmer off, press Multi-Control
again.