Sanyo HEC-DR5700 Instruction Manual page 22

MASSAGING (MANUAL COURSES) (continued)
5
Press the MANUAL button.
6
Press the desired MANUAL (UPPER BODY)
MASSAGING button.
Refer to pages 22 - 23 for details of the contents of massage.
●
For spine stretching (full), the shoulder position is first measured.
●
When the position of shoulder is not correct, adjust the position of
massaging rollers. (See page 17)
During massaging operation, the operation can be changed to
●
other manual massage, Whole Body Sensor Automatic Course or
Automatic Courses.
It is possible to operate the upper body massage and lower body
●
massage simultaneously. However, upper body massage and
TWIST massage cannot be used simultaneously.
＊ The massage will not start without pressing MANUAL button,
even if the MANUAL (UPPER BODY) MASSAGING buttons are
pressed. (In such a case, the MANUAL button flickers five times.)
7
Adjust the height, width, speed, and strength of the massaging rollers.
There are some adjustments which are not possible, depending on the type of massage chosen.
●
(See page 22-23)
Adjusting the height of massaging rollers.
Press the button.
The massaging rollers will move up if the
UP( ) button is pressed continuously and
move down if the DOWN(
pressed continuously.
The approximate position of the massaging rollers
●
is indicated by the lamp on the remote control.
Adjusting the movement speed of massaging rollers.
Press the button.
The speed of the massaging rollers will change
●
each time the button is pressed, and is indicated
by the lamp on the remote
control. (in five stages)
Finishes massaging automatically by timer operation.
■
The massaging rollers are moved to the upper position and are stopped automatically approx. 15 minutes
●
after starting the operation. The beep sounds and the lamp on the remote control will turn off.
If a different course button (manual) is pressed during the course of operation, the massage will be
●
completed by operation of the timer approx. 30 minutes after starting the massage selected first.
To stop the massage during operation.
Press the OPERATION ON/OFF button.
All the massaging will stop.
●
(The massaging rollers are moved to the
upper position and remain in that position.)
Press the button for the current operation.
The massaging that corresponds to the
●
pressed button will stop. (The Massaging
rollers will stop at that point.)
21
MANUAL button
The width of the massaging rollers will
●
) button is
The strength of the massage will change each
●
If you have felt abnormal physical sensation or want to stop the massager immediately
Press the INSTANT STOP button.
All the massaging will stop and the lamp of the remote
●
control will turn off.
When you want to restart massaging, press the
●
OPERATION ON/OFF button. (The massaging rollers
move to the upper position and remain in that
position.)
After the movement, repeat the operation to begin a
massage.
MANUAL (UPPER BODY)
MASSAGING buttons
Adjusting the width of the massaging rollers.
Press the button.
change each time the button is pressed and is
indicated by the lamp on the remote control.
(in five stages)
Adjusting the strength of drum roll massaging.
Press the button.
time the button is pressed, and is indicated by
the lamp on the remote
control. (in five stages)