Sanyo HEC-DR5700 Instruction Manual page 17

6
Starts massaging automatically.
Measure the position of shoulder.
①
Check if the position of shoulder is correct. If not, adjust the position using the POSITION ADJUST buttons.
●
(The POSITION ADJUST buttons can also be used while massaging is in progress.) (See page17)
Sensor massaging will start.
②
Measures the degree of stiffness in each part of body with the
sensor and informs of the degree of stiffness.
→Massaging operation and the display of remote control.
Massages according to detected stiffness.
③
Adjusts the operation and strength of standard massaging
according to the measured degree of stiffness.
→Massaging operation and the display of remote control.
7
Adjust the strength of massage.
Finishes massaging automatically by timer operation.
■
Massaging rollers are moved to the upper position, and stop massaging automatically.
●
The beep sounds and the lamp on the remote control will turn off.
The massaging time differs according to the detected stiffness, but the maximum is approx. 20 minutes.
●
NOTE
Massage in relaxed condition as much as possible. The degree of stiffness may not be measured correctly
●
when the user is given stimulation other than sensor massage.
Examples of this are if the user massages immediately after taking a bath or while watching TV.
The measurement result indicates the stiffness according to the body's biological reaction (the amount of
●
perspiration from fingers) to the sensor massage, so it may differ from the stiffness the user actually feels.
To stop the massage during operation.
Press the OPERATION ON/OFF button.
All the massaging will stop.
●
(The massaging rollers are moved to the
upper position and remain in that position.)
Press the button for the current operation.
The massaging that corresponds to the
●
pressed button will stop. (The Massaging
rollers will stop at that point.)
(See page 17)
(See page 17)
(See page 17)
If you have felt abnormal physical sensation or want to stop the massager immediately
Press the INSTANT STOP button.
All the massaging will stop and the lamp of the remote
●
control will turn off.
When you want to restart massaging, press the
●
OPERATION ON/OFF button. (The massaging rollers
move to the upper position and remain in that
position.)
After the movement, repeat the operation to begin a
massage.
16