Operation Warning - DeWalt DCBL720 Instruction Manual

Components (Fig. 2)
A. Variable speed trigger E. Battery housing
B. Speed lock lever F. Battery pack
C. Handle G. Battery release button
D. Tube
FIG. 2
D
ASSEmBLy (FIG. 3)
CAUTION:
Ensure the battery is removed before
attaching or removing the tube (D). The tube must be attached to the
housing (3A) before use.
• tuBe aSSeMBLy: To attach the tube to the blower, line up the
pegs (3B) on the bottom of the
tube with the notch (3C) on the
bottom of the housing opening as
shown in figure 3. Push the tube
into the blower housing until the lock
engages the tube and an audible
click is heard.
• Pull on the tube to ensure it is securely
in place.
B
C
A
E
G
F
FIG. 3
D
3A
3B
3C
3D
• To remove the tube, insert a screwdriver into the unlocking hole
(3D) on the side of the housing. Lift the tab inside and pull tube out.
OPERATIOn
WARNING:
securely in place. Never reach down into housing through tube hole.
WARNING:
• You leave blower unattended and when storing.
• Checking, adjusting, cleaning, or working on blower.
Installing and Removing the Battery Pack
(Fig. 2, 4, 5)
to install battery pack: Insert battery pack (F) into battery housing
(E) as shown in Figure 4 until fully seated and an audible click is heard.
Make sure battery pack is fully seated and fully latched into position.
to remove battery pack: Depress the battery release button (G) in
the top of the battery housing and pull battery pack out of appliance
as shown in Figure 5.
FIG. 4
E
Fuel Gauge Battery Packs (Fig. 6)
Some D WALT battery packs include a fuel gauge which consists of
e
three green LED lights that indicate the level of charge remaining in the
battery pack.
8
Do not operate blower without tube
Always remove the battery when:
FIG. 5
F
G