When Using Die-Cut Labels - LabelTac LT9 Reference Manual

When using die-cut labels...

1
Load the die-cut material in the printer, leaving a small
amount of the first label leading out of the mouth of the
printer.
2
When ready to print your label, first go to 'Printing
Preferences' for your LabelTac
the top of the window, click 'Stock'.
3 Under 'Type' in the 'Media Settings' section, change from
'Continuous' to 'Labels with Gaps'. Click OK.
4 Change the number of copies to print to '1',
that already)
**
The printer will print this first label off-center, and the print will overlap
into part of the second label. This is normal.
by reading the gaps between the labels, and once it reaches the end of the
second label, it will be fully calibrated and aligned.)
5
Go back and print the rest of the labels as normal.
To switch back to using standard continuous vinyl, simply return to the 'Printing
Preferences' window and change the Media Type back to 'Continuous'.
24 Using LabelTac
and click Print/OK to begin printing.
When using die-cut labels...
®
(see page 22). In the tabs at
®
(The printer self-calibrates itself
(if it isn't set to