Resetting - Mercedes-Benz E-Class Cabriolet 2016 Operator's Manual

Side windows
84
Using the SmartKey
G
WARNING
While closing the side windows, body parts in
the closing area could become trapped. There
is a risk of injury.
When closing make sure that no parts of the
body are in the closing area. If somebody
becomes trapped, release the switch or press
the switch to open the side window again.
You can use the SmartKey to open or close all
side windows simultaneously. The SmartKey
must be near the door handle.
Close the soft top (
X
Open the trunk partition (
X
To open all side windows: press the %
X
button on the SmartKey until the side win-
dows are fully opened.
To interrupt the opening procedure:
X
release the % button.
To close all side windows: press the &
X
button on the SmartKey until the side win-
dows are fully closed.
To interrupt the closing procedure: release
X
the & button.
Convenience closing with KEYLESS-GO
G
WARNING
When using the convenience closing feature,
parts of the body could be trapped in the clos-
ing area when a side window is being closed.
There is a risk of injury.
Observe the complete closing procedure
when the convenience closing feature is oper-
ating. Make sure that no body parts are in
close proximity during the closing procedure.
Proceed as follows if someone is trapped:
Release recessed sensor surface on the door
X
handle.
Immediately pull and hold the door handle
X
and keep the door handle pulled.
The side windows open.
With KEYLESS-GO you can close all side win-
dows simultaneously. The KEYLESS-GO key
must be outside the vehicle. All the doors must
be closed.
page 86).
Y
page 91).
Y
Touch recessed sensor surface : on the
X
door handle until the side windows are fully
closed.
i
Make sure you only touch recessed sensor
surface :.
To interrupt convenience closing: release
X
recessed sensor surface : on the door han-
dle.
Resetting the side windows
If a side window can no longer be closed fully,
you must reset it.
Close all the doors.
X
Turn the SmartKey to position 1 or 2 in the
X
ignition lock.
Pull the corresponding switch on the door
X
control panel until the side window is com-
pletely closed ( page 83).
Y
Hold the switch for an additional second.
X
If the side window opens again slightly:
Immediately pull the corresponding switch on
X
the door control panel until the side window is
completely closed (
Y
Hold the switch for an additional second.
X
If the respective side window remains closed
X
after the button is released, then it has been
set correctly. If this is not the case, repeat the
steps above again.
page 83).