Advertisement
USE & OPERATION (CONTINUED)
REMOTE CONTROL (CONTINUED)
•
Do not mix different types of batteries such as alkaline, carbon-zinc, or rechargeable batteries.
•
Do not mix old and new batteries.
•
Exhausted batteries are to be removed from the product.
COOLER LOCATION
Make sure to position the air cooler correctly before you set up and start using the product. Please refer
to the COOLER LOCATION section of the separate Safety & Maintenance Guide.
FILLING WITH WATER
CAUTION:
Unplug the unit from the electrical power outlet before filling or emptying the water tank
Continuous Water Supply Connection:
For a continuous water supply, you will need a garden hose that is
connected to a main water supply
•
Locate the male connector at one end of the garden hose. Insert the
garden hose connector into the water inlet valve of the cooler. Screw
and tighten the water inlet valve onto the threaded part of the garden
hose connector, making sure the hose connector is secured to
ensure there will be no leaks. If there is leakage, the hose and the
water inlet valve may not be connected properly. Try to disconnect,
replace and tighten the water inlet valve again.
•
When the connection is secured, turn ON the water supply and the
water will flow into the water tank of the cooler.
•
The cooler is now set so the water refills automatically when the
water tank is empty, or when the water reaches below a minimum
level.
•
When the water tank is full, the water inlet valve will automatically
stop the water supply from overflowing.
WARNING: The maximum water inlet pressure is 0.5 MPa.
Manual Water Tank Refill:
Open the Water Fill Door located on the side of the unit.
The Water Level Indicator is located at the front of the unit. Refill the
water tank when water level is low. To avoid water spillage and water
droplets at the louvers, do not fill water above the "MAX" indicator level.
Check the water level in the tank before running the COOL function.
Make sure that the water in the tank is above the minimum water level
mark. Running the unit in COOL mode with inadequate water may
cause pump failure.
Note: If ice is available, you may add ice in the ice tray to enhance the
cooling performance.
Water
inlet valve
Garden Hose
Water Fill Door
Ice Tray
3
Advertisement
