Table of Contents
Advertisement
70330 rev1
19/6/08
J
K
L
U U K K H H e e l l p p l l i i n n e e 0 0 8 8 4 4 4 4 8 8 7 7 1 1 0 0 9 9 4 4 9 9
6 6
10:15
Page 6
CLEANING THE
SPILLMASTER
It is recommended that the
SpillMaster is regularly cleaned
to prevent any build up of
residue.
Remove the filter by squeezing
the two white areas with a finger
and thumb and pull the white
tab until the filter is clear of the
product J.
Separate the SpillMaster into it's
two parts as described in the
'Emptying the SpillMaster'
section.
Empty the contents of the base
unit over a sink and then rinse
the reservoir with lukewarm
water to remove any residue.
Leave to dry upside down for at
least 24 hours or until
completely dry K.
HINTS & TIPS
(also see 'Safety Features')
•
The SpillMaster can be used on
all floor types but must only be
used for liquid spills.
•
It has not been designed to
suck up solids. If any solids
have accidentally been sucked
up, follow the advice in the
'Cleaning' section.
•
Hold the SpillMaster ensuring
the bleed holes are not
obstructed L. If the bleed holes
are covered, this could result in
your vacuum cleaner over
heating.
•
Do not attempt to overfill past
the max fill line. If overfilled, the
float safety cut-out will be
activated and the suction will
cease.
•
If the float is activated, switch
the vacuum cleaner off and
empty the reservoir. The float will
drop back into it's original
position.
R R e e p p l l a a c c e e m m e e n n t t P P a a r r t t s s 0 0 8 8 4 4 4 4 8 8 7 7 3 3 0 0 7 7 1 1 5 5
•
After use, empty the contents of
the water tank, clean and dry
the product fully.
•
Regularly check that the filter is
not blocked, dirty or damp. If
the filter becomes dirty, rinse in
lukewarm water and leave to dry
fully before re-use.
•
If the filter becomes damaged, it
must be replaced. Call our
helpline for replacement parts.
•
When carrying the SpillMaster
to the sink, ensure it is kept
horizontal to prevent any
spillage.
PRODUCT STORAGE
•
When finished, do not store
near any heat sources.
•
Store in an upright, flat position.
•
Only store when dry.
HELPLINE
If you have any difficulty with
your appliance, do not hesitate
to call us.
We are more likely to be able
to help than the store from
where you bought it.
Please have the following
information ready to enable our
staff to deal with your query
quickly.
•
Name of the product
•
Model number as shown on the
underside of the appliance.
•
Serial number as shown on
underside of the appliance.
UK Helpline
0844 871 0949
Replacement Parts 0844 873 0715
Ireland Helpline
1800 409 119
I I r r e e l l a a n n d d H H e e l l p p l l i i n n e e 1 1 8 8 0 0 0 0 4 4 0 0 9 9 1 1 1 1 9 9
Advertisement
Table of Contents
