Motor Protection Filter; Exhaust Filter - Morphy Richards PerformAir Upright Vacuum Instructions Manual

73352 rev2 22/6/06 11:09
E
F
G
¯
H
ˆ
I
‰
Page 5
hose connector.
3 Add the required accessory to
the extension tubes or directly
to the tube connector Ï when
using the hose and tools.
IMPORTANT: Turning the cleaner
sideways helps prevent the
cleaner being pulled along by
the stretch hose.
IMPORTANT: Remove the hose
connector before returning to
floor cleaning with the main
nozzle. Push the flap down to
disengage the latch before
pulling out the connector.
Using & cleaning the
turbo nozzle
(Certain models only)
Attach the turbo nozzle to the
tube connector for use on
upholstery and stairs.
After use your turbo nozzle may
become clogged. Turn over the
nozzle and pull away any hairs
or fibres. If they are tightly
wound around the brush
carefully snip the fibres with
scissors, being careful not to
damage the brush bar, pull away
from the bar and dispose.
DUST CANISTER
Emptying
1 Remove the dust canister from
the product by pressing the
canister release button E ›.
2 Every time the dust canister is
emptied, slide the filter cleaning
clicker lever F fl several times
before emptying (this will agitate
the fine dust between the filter
pleats and restore the air flow).
3 Holding the canister over a
dustbin press the one touch
empty button G ¯ and the
bottom of the canister will drop
down and release the dirt.
4 Close the bottom of the dust
canister by pressing the base
upwards until it clicks into place.
5 Re-fit dust canister and push
back into position.
www.morphyrichards.com
Allergy sufferers
If the allergy suffer is emptying
the product it is recommended
that the container is placed into
a plastic bag to empty.
1
Place the container inside the
plastic bag, releasing the
container with one hand whilst
holding the top of the bag
closed with the other, leave the
dust to settle for a few seconds
before removing the canister.
The plastic bag can then be
sealed and disposed of.
FILTERS
Using the filter cleaning lever at
every emptying will help
maintain good suction however
for a through clean the dust
canister and dust canister filters
may be dissembled and
washed.
Motor protection
filter
The motor protection filter ˆ is
located underneath the dust
canister. H
Remove the dust canister. E
1
2 Lift out the filter and shake over
a dustbin. The filter may also be
washed in water (no detergents)
but must be totally dry before
re-fitting.
3 Replace the filter.

Exhaust filter

The allergy exhaust filter should
be replaced every 6 months to
maintain the high performance
filtration. Call our Replacement
Parts Helpline.
The exhaust filter is located
below the dust canister
compartment.
1 Remove the exhaust filter grille.
‰ I
Remove the exhaust filter Ê by
2
pulling forward at the top and
lifting away.
5