Stihl FS 130 Instruction Manual page 25

4
3
5
6
7
Place the clamp (3) in the loop
N
handle (4) and position them both
against the drive tube (5).
Place the clamp (6) against the
N
drive tube.
Place the barrier bar (2) in position
N
as shown.
Line up the holes.
N
Insert the screws (7) and tighten
N
them down moderately against the
barrier bar.
Go to "Securing the Loop Handle".
N
FS 130, FS 130 R
Mounting the Loop Handle without
Barrier Bar
2
Place the clamp (3) in the loop
N
handle (4) and position them both
against the drive tube (5).
Place the clamp (6) against the
N
drive tube.
Line up the holes.
N
Fit washers (7) on the screws (8)
N
and insert the screws in the holes.
Fit the square nuts (1) and screw
them down as far as stop.
Go to "Securing the Loop Handle".
N
8
8
7
7
4
3
5
6
1
1
Securing the Loop Handle
A
9
10
Secure the loop handle (4)
N
approx. 8 in (20 cm) (A) forward of
the control handle (9).
Line up the loop handle.
N
Tighten down the screws firmly –
N
lock the nuts if necessary.
The sleeve (10) (not fitted on all models)
must be between the loop handle and
the control handle.
English
4
23