The headband, wireframe, and gooseneck are adjustable to accommodate any head size or shape. The WH20 is supplied with a foam windscreen and clothing clip. FEATURES Lightweight wireframe and headband adjust for a secure, comfortable fit...
MICROPHONE PARTS FIGURE 1 COLLAPSIBLE MICROPHONE BOOM The WH20 headset features a collapsible boom for shipment and storage. Before wearing the headset, unfold the boom until it snaps and locks into place. Refold for storage or transportation. WEARING THE HEADSET...
WEARING THE HEADSET POSITIONING THE MICROPHONE FIGURE 2 FIGURE 3 ADJUSTING THE HEADSET If the headset feels loose or uncomfortable, carefully bend the sides of the wireframe to make it tighter or looser (Figure 4A). The angle of the wire- frame earpieces may also need adjustment (Figure 4B).
OPERATION Connect the WH20 to the microphone input of a wireless microphone transmitter or a balanced wired microphone input. NOTE: The WH20 is a dynamic microphone and has inherently lower output than condenser microphones.
When the windscreen is dry, slide it over the WH20 microphone. WASHING THE ELASTIC HEADBAND The elastic headband can be removed from the wireframe and hand-washed in a mild soapy water solution. To remove and wash the headband, follow these steps: Remove the microphone cable retainer from the wireframe.
Page 7
(ground) of microphone output phone plug connector. WH20QTR, WH20TQG used with Shure Wireless Systems: -inch Phone Jack Receiver Outputs: Positive sound pressure on diaphragm produces positive voltage on tip of receiver output connector.
--10 1,000 2,000 5,000 10,000 20,000 TYPICAL FREQUENCY RESPONSE FIGURE 6 --20 dB --15 dB --10 dB 500 Hz --5 dB 1000 Hz 4000 Hz TYPICAL POLAR PATTERNS FIGURE 7 CERTIFICATION Conforms to European Union directives, eligible to bear CE marking; meets European Union EMC Immunity Requirements (EN 50 082-1, 1992).
Page 9
MODEL WH20QTR CARTRIDGE 1/4” CONNECTOR BLACK SLEEVE SHIELD MODEL WH20XLR CARTRIDGE XLR CONNECTOR SHIELD BLACK MODEL WH20TQG CARTRIDGE TINI Q-G CONNECTOR BLACK SHIELD WIRING DIAGRAMS FIGURE 8...
Page 10
Trademark Notices: The stylized Shure logo and the words “Shure” and “The Sound of Professionals... Worldwide” are registered trademarks of Shure Incorporated in the United States. “Teflon” is a registered trademark of E.I. duPont de Nemours and Company in the United States. “Croakies” is a registered trademark of Life-Link International, Inc.