Bluetooth Mode Operation; Pairing; What Display Can Show During The Incoming/Outcoming Call Mode - Boss Audio Systems MR1309UAB User Manual

BLUETOOTH MODE OPERATION

INSTRUCTION FOR HANDSFREE FUNCTION
1. PAIR IT WITH YOUR PHONE (PAIRING)
Before you use your Car HANDSFREE System, you need to pair it with your mobile phone.
1. The Bluetooth set system on the head unit will automatically go into pairing mode when the
POWER turned on .
2. Set your Bluetooth phone to discover the BOSS AUDIO
3. Your phone will find the BOSS AUDIO
Your phone then asks if you want to pair with it. Accept by pressing Yes or OK on the phone
and confirm with the passkey or PIN=0000 (4 zeros). Your phone will confirm when pairing is
complete.
In case of unsuccessful pairing, repeat steps 1 to 3 .
2. OPERATION
Call Accept: Single click TALK button during an incoming call to accept the call.
Call Reject: Click CANCEL (SRC
reject the call.
Call End: Single click SRC
hang up.
Call Disconnect: No BT mode Click TALK button about 1.5 seconds when it is not in
communication mode. And Disconnect and BT OFF will showed on the display.
Call Re-connect,Click TALK button again at the Disconnect Status. The connection will be
reconnected and CONNECT & BT ON will showed on the display.
Call Transfer (Private mode): Click TALK button about 1.5 seconds at communicating time,
transfer the call to phone, click talk button once again, transfer the call to Bluetooth.
Auto Answer (Depend on mobile phone feature): Pls refer to your own mobile phone
manual for handsfree auto answer setting.
Volume Adjust: User can use the volume up/down to adjust the volume level.
3. WHAT DISPLAY CAN SHOW DURING THE INCOMING/OUTGOING CALL MODE
INCOMING CALL
When there is an incoming call, the display will display the incoming caller telephone
number If the incoming call has no caller number, the LCD will display 00000000 user can
short press the TALK button answer / accept the call and the Talking display will be showed
when the call is answered.
To end the conversation, press the CANCEL(SRC
the Hang up will showed on display. The unit and the display on the LCD will switch back to
the previous mode automatically.
OUTGOING CALL
User can use his / her Mobile Phone or remote control to dial and make an outgoing call .
Once the user start dialling, the display should show DIALING.
The audio output of the present mode will ONLY be muted after pressing the TALK button as
a confirmation to dial the outgoing call.
During talking mode, the LCD Display will display talking time.
To end the conversation, press the CANCEL (SRC
control and the Hang up will showed on display. The unit and the display on the LCD will
switch back to the previous mode automatically. The mute of the previous mode will be
released at the same time.
) or (STOP) on the remote during an incoming call will
button when communication or dialling an outgoing call to
) or (STOP) at the Remote control and
E -12
) button or (STOP) at the Remote