FOR-A MBP-120SX Operation Manual page 18

4. The following message appears. Check that Boot Command is set to DISABLE, and then
press any key on the keyboard once. Windows automatically restarts.
** Enabling overlay
Protected Volume Configuration
Type
State
Boot Command
Param1
Param2
Persistent Data
Volume ID
Device Name
Max Levels
Clump Size
Current Level
Memory used for data 0 bytes
Memory used for mapping 0 bytes
***************************************************************************
The write-protection for the boot drive was set to disable.
It is reflected in the next boot. Please restart the Windows.
***************************************************************************
Press any key to continue . . .
5. After restarting, the listed start-up programs start automatically. Close all programs.
The system is now ready to change settings or install new applications.
Note that when powering off the MBP-120SX/125SX while the write protection is
disabled, Windows must be shut down before powering off. Powering off without
shutdown may corrupt data.
RAM<REG>
ENABLED
DISABLE
0
0
'' ''
XX XX XX XX XX XX XX XX XX XX XX XX XX XX XX XX
''\Device\HarddiskVolume1'' [C: ]
1
512
N/A
IMPORTANT
18