Load Factory Default; Software Upgrade; Upgrade By Rs-232; Upgrade By Air - FaVal Aquila T 200 User Manual

Digital Terrestrischer Receiver FaVal Aquila T 200/
_____________________________________________________________________________________

8.3 Load Factory Default

When you press [OK] key In the "Load Factory Default"
item:
There will pop a dialogue for you to enter the password,
and the default password is "0000".
After you input the correct password, there will show a
warning message to inquiry you "The operation will
load default and erase all the channels that user
added, continue?".
If you select "Yes" option, the all revised parameters of
the receiver will reset to default value. Please carefully
to using this function.
In step 1 and step 2, press [Exit] key can draw back from this item and without saving.

8.4 Software Upgrade

When you enter to "Software Upgrade" menu, you will
see the window as below:

8.4.1 Upgrade By RS-232

Transfer Mode:P2P/ P2M. P2P means one STB upgrade
the other one. P2M means one STB upgrade several
other boxes at same time.
When Transfer Mode is "P2P", "Upgrade Mode" is valid.
Press [Left/Right] keys to switch upgrade mode.
Upgrade modes include: ALL / CODE / LOGO / COUNTRYBAND / DATABASE.
When connectting the master and one slaver, Turn on slave receiver and it needn't
operate any setting. Moving highlight to "Start" on master reeciver and press [OK]
key to start upgrade.
When Transfer Mode is "P2M", "Upgrade Mode" is invalid. Default is "All".
When connectting the master and multi slavers, you can move highlight to "Start" on
master reeciver and press [OK] key to start. Turn on all slavers receiver and press [OK]
again on master to begin to upgrade. 6 Press [Exit] key to save the parameters and
draw back.
Press [Exit] key to save the parameters and draw back.

8.4.2 Upgrade By Air

This function can upgrade the software through signal
lines from the cable.
1 Input the frequency value and download PID, and
select bandwidth.
2 Then move the highlight to the start button and press
[Enter] key to begin to upgrade.
Digital Terrestrial Receiver
- 14 -