Universal Garage Door Opener (Homelink ) - Jeep 2014 Compass User Manual

ELECTRONICS
UNIVERSAL GARAGE DOOR OPENER (HomeLink®)
• HomeLink ® replaces up to three hand-held transmitters that operate devices
such as garage door openers, motorized gates, lighting or home security systems.
The HomeLink ®
• The HomeLink
®
designate the three different HomeLink
• The HomeLink ®
Before You Begin Programming
HomeLink®
• Ensure that your vehicle is parked out-
side of the garage before you begin
programming.
• For efficient programming and accurate
transmission of the radio-frequency sig-
nal, it is recommended that a new bat-
tery be placed in the hand-held trans-
mitter of the device that is being
programmed to the HomeLink
• Erase all channels before you begin programming. To erase the channels, place
the ignition switch into the ON/RUN position, then press and hold the two outside
HomeLink ® buttons (I and III) for up to 20 seconds or until the red indicator
flashes.
NOTE:
Erasing all channels should only be performed when programming HomeLink
the first time. Do not erase channels when programming additional buttons.
• If you have any problems, or require assistance, please call toll-free 1–800–355–
3515 or, on the Internet at www.HomeLink.com for information or assistance.
Programming A Rolling Code
• For programming Garage Door Openers that were manufactured after 1995. These
Garage Door Openers can be identified by the "LEARN" or "TRAIN" button located
where the hanging antenna is attached to the Garage Door Opener. It is NOT the
button that is normally used to open and close the door. The name and color of the
button may vary by manufacturer.
1. Place the ignition switch into the ON/RUN position.
2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink
button you wish to program while keeping the HomeLink
3. Simultaneously press and hold both the HomeLink
and the hand-held transmitter button.
62
unit is powered by your vehicles 12 Volt battery.
buttons that are located in the overhead console or sunvisor
indicator is located above the center button.
® system.
channels.
®
®
® button you want to program
®
indicator light in view.
for
®