Features Of Your Iron - Morphy Richards Breeze 40310 Instructions Manual

40310 Rev 2 24/8/07
This is perfectly normal as it shows that
the iron is maintaining the heat setting you
have chosen.
It is always a good idea to begin with
cool fabrics and work up to higher settings.
An iron heats up quicker than it cools
down so you'll save time and electricity.

Features of your iron

Temperature indicator light
The indicator light shows that the iron is
warming up. When the required temperature
is reached the light will go out and will cycle
on-off during operation.
Dry ironing
You can use your iron as a dry iron only.
Make sure the steam control ⁄ is set to the
' ' symbol.
Any temperature setting may be used
depending on the garment. The spray
feature may be used provided there is water
in the tank (see filling section). You do not
need to put any water in the tank when dry
ironing only.
Spray
Press the spray
button ¤ and aim the
spray of water at
stubborn creases. You
can do this whilst dry
ironing providing there
is water in the tank.
When using the water
spray it may be necessary to push the
button a few times to get the spray pump
primed.
Steam control
Fill the iron with water as described in
'Filling', page 4 and insert the plug into the
electrical socket.
The steam output can be switched from
off to on by sliding the steam control C. ⁄
15:08 Page 5
Steam
The steam facility should only be used
on garments which are suitable for ironing
at 2 and 3 dot setting.
Shot of steam (certain models only)
Press the shot of steam button ‹ to
obtain a burst of extra
steam for ironing out
creases in heavy material
such as denim etc.
The shot of steam can
be used whilst dry ironing,
providing there is water in
the tank, and the
temperature control is set
within the steam range.
Do not use shot of steam at
temperatures below the steam range shown
on the control.
Note: For optimum steam quality, do not
operate the shot more than three times in
succession.
Variable steam (certain models only)
Fill the iron with water as described in
'filling', page 4 and insert the plug into the
electrical socket.
The steam output can be varied from
low to high by the sliding the variable steam
control C. When using the iron at the
bottom of the steam temperature range, the
steam output should be adjusted to the
lowest setting.
5
C
No steam